Drivers & Downloads : CRT Projection

Date of Release: 01/01/2005 5:00 AM

Version:

2.1

Operating System:

Windows XP

Models:

PT-47WXD63, PT-53WXD63, PT-53TWD63, PT-56TWD63

Instructions:

Download this zip file (TXFSD03GSER.zip)
Unzip the file and save it to your SD card (over 16MB is needed)
NOTE: When unzipping the file, make sure to extract "All files" with "User folder names"
Confirm that there is a folder named "PRIVATE" and a file named "SDIT.SDI" on the SD card.
Remove the SD card from your computer.
Unplug the unit from the wall outlet.
Insert the SD card into the SD card slot located at the back, which says "SERVICE ONLY"
NOTE: Check the direction of the card when inserting. See below.

Instructions

Plug the unit into wall outlet, and turn ON the unit.
Wait until the unit is turned ON. (It might take more than a minute to turn ON). When unit turns ON, wait for and confirm the screen below.
Press "OK" to start the firmware upgrade to begin.
NOTE: DO NOT TURN OFF THE UNIT UNTIL UPGRADE IS COMPLETED!
When the firmware copy is completed, the following screen will appear.
Follow the instruction on the screen.
At this point, the firmware upgrade to your unit has been completed.
Run "AUTO SCAN" to re-program the channels on the unit.
If the channels are not programmed after the firmware upgrade, your unit might not capture a channel correctly.
Please refer to your Owner's Manual page 4 for AUTO SCAN procedure.